Tower crane swing paths and heavy earthmoving blind spots cause 11% of construction fatalities. RigSafeLens tracks rotating boom positions, suspended load trajectories, and ground personnel in 3D space — alerting crane cabs and ground spotters in under 0.2 seconds.
Standard mirrors and backup beepers fail in noisy, high-density jobsites. Our AI vision continuously tracks vectors between iron and workers.
Calculates dynamic 3D exclusion cones underneath rotating jibs and hoisted loads, sounding floor sirens before suspended steel swings over crews.
Monitors 360° rear counterweight swing radiuses on large hydraulic track excavators, preventing lethal pinch-point and trench crushing accidents.
Enforces OSHA 1926.1408 minimum clearance buffers between concrete pump truck booms, boom trucks, and high-voltage transmission lines.
Detects stationary live loads suspended by crane hooks without active tag line handlers or spotters, penalizing unsafe rigging staging.
Separates foot traffic pathways from heavy vehicle material channels. Sends automated warnings when pedestrians cross active forklift zones.
Integrates high-sensitivity thermal and low-lux cameras to maintain full perimeter protection during overnight bridge girder and truss placements.
Unlike static painted barriers, RigSafeLens exclusion cones adapt in real-time to load mass, slewing velocity, and wind speed.
Cameras mounted on mast heads and surrounding perimeter towers track jib tip elevation, trolley position, and hook block azimuth at 30 FPS.
The vision engine computes a 3D fall cone beneath the load. The cone expands dynamically when the crane accelerates or when wind gusts cause load swing.
The operator cab buzzer sounds in <140ms while floor supervisor tablets receive snapshot coordinates, allowing immediate verbal halt commands.
Designed directly to satisfy federal requirements for cranes and derricks in construction (29 CFR 1926.1400).
Mandates that employers prevent employees from entering hazardous areas within the swing radius of equipment. RigSafeLens generates continuous digital proof that swing boundaries were actively monitored and enforced.
Strictly prohibits employees from standing within the fall zone while loads are being lifted or unhooked. RigSafeLens triggers horn tones if non-rigging personnel enter within 1.5x the hook elevation radius.
Demands minimum 20-foot standoff clearances from unverified power lines. RigSafeLens establishes software geofence hard stops that alert operators whenever boom tips approach high-voltage corridors.
Connect RigSafeLens to your existing crane and jobsite cameras in under 4 hours. No expensive hardware retrofits required.